Skip to main content

MIDI Forum

Clemens Ladisch
Clemens Ladisch
Joined: Jan 20, 2016
Last seen: Apr 1, 2025
Topics: 1 / Replies: 329
Reply

A note-on message with a velocity of zero must be interpreted as note off. But I guess you do get a non-zero velocity in those messages? What devic...

7 years ago
Reply

This is called voice allocation; in general, there is no fixed association between notes and voices, and whenever a note must be played, you choose an...

7 years ago
Reply

The USB protocol makes a strict distinction between devices and hosts, and allows connections only between each other, but not between the same type. ...

7 years ago
Reply

The USB MIDI protocol does not use running status. When the CH345 firmware encounters a missing (running) status byte, it inserts not the last status ...

7 years ago
Reply

USB2.0-MIDIThat name indicates that your USB/MIDI interface (which probably looks like this) is based on the CH345 chip, which is broken. Its two most...

7 years ago
Reply

The cable shield (pin 2) should be connected to ground at the sender, but left open (or AC-grounded through a capacitor, see the Electrical Specificat...

7 years ago
Reply

The MIDI Solutions Router must be programmed over MIDI. The Sipario is described as "Advanced MIDI Router", so it should be able to do what you want....

7 years ago
Reply

Nomally, the total 7-bit sum of the dump data, including the checksum byte, should add to 7-bit zero. That's what the GS and XG standards use, but ...

7 years ago
Reply

The 7-pin connector was chosen because it is compatible with 5-pin ones, so the first five pins indeed must be the same. There is no official speci...

7 years ago
Reply

When the internal data is organized as 8-bit bytes, some encoding (not compression) must be used to transport it using 7-bit bytes (as used in the Sys...

7 years ago
Reply

It appears nobody here has both devices. In general, sound quality is influenced by how much the MIDI files are optimized for the specific sounds o...

7 years ago
Reply

Doepfer makes OEM/DIY products like this; have a look at the CTM64 or USB64. If you can create circuit boards yourself, have a look at uCApps/MIDIb...

7 years ago
Reply

What controller? Which port of the controller did you connect to which port on the Fantom? Did you do any configuration on either device?

7 years ago
Reply

Apparently, there's nothing that you (as a user or programmer) can do. (… Well, stop unplugging devices while they're still being used.)

7 years ago
Reply

A MIDI line is idle most of the time, so the average current is not 2.5 mA, but approximately zero. To measure the current during a zero bit, you n...

7 years ago
Page 15 / 22