MIDI Forum

What controller? Which port of the controller did you connect to which port on the Fantom? Did you do any configuration on either device?

Apparently, there's nothing that you (as a user or programmer) can do. (… Well, stop unplugging devices while they're still being used.)

A MIDI line is idle most of the time, so the average current is not 2.5 mA, but approximately zero. To measure the current during a zero bit, you n...

I don't have the MR 76; my only rabbit was Google. If you connect the MR's MIDI Out directly to its MIDI In, can you play sounds through that? And...

The MR/ZR Getting Started Guide says: MIDI connections with a computer: MIDI Out of the MR/ZR to MIDI In of the computer MIDI Out of the computer t...

Colin, to find out which component is responsible, could you try recording MIDI on some other PC, or with some other MIDI sequencer?

Are you talking about latency or jitter? Does it sound OK if you later play back the recorded MIDI data through the PSR?

Your computer will not recognize the Korg but the MIDI interface. What kind of file have you downloaded? .mid or .syx or something else?

Related, but probably not the same as your problem: How can i make my synth leads polyphonic? Is it possible that you somehow configured Garageband...

Page 223 of the Owner's Manual shows the DT1 SysEx message (see Eddie's tutorial for another explanation of the checksum); page 230 shows the addresse...

Can you check if generating sounds with the guitar pickup works? What is the difference between the tunes that work and those that don't? Are they ...

There is no standard method. It would be possible to either change the tick duration, or to move the events to some other tick.

The "Set Tempo" meta event is exactly defined: it specifies the length of a "quarter note" in microseconds. (A "quarter note" is not necessarily relat...

Everything points to The Grid being the problem. And as you have observed, it never sends many MIDI messages. I suspect that this has nothing to do w...

The calculations presented in both the original and revised 2014 spec to calculate the loop current seem to assume the output buffer is able to drive ...