Hello all! I have an idea for something I'd like to be able to do with a few pieces of hardware gear and having trouble figuring out the best method to achieve it.

I have a Syncussion SY-1 two channel drum synthesizer that I'd like to be able to control using a multi-pad percussion device. The Syncussion has CV inputs for Trig and Tune for each channel. I can control these independently just fine using a single device and send note trigger, and also change the pitch with the tune CV input.

Here's a photo of the connections there:

Also a link to the documentation for the unit:

I am looking to use a percussion controller similar to the Roland Octapad where I can split the top four pads of the Octapad out to Channel 1 of the Syncussion, and the bottom four pads of the Octapad to Channel 2 of the Syncussion.

I have a CV OCD MIDI to CV box that I've been using, and also have the Octapad and SY-1. I can't seem to figure out a hardware method to achieve what it is I am looking to do. Here's a photo of the CV OCD:

I just think it would be ideal for me from a performance standpoint to have four assigned notes per channel that I can drum between, CH-1 on the top 4 and CH-2 on the bottom 4. My idea is to have some different note assignments that I can switch between using a foot controller to change on the Octapad. It seems like I might have to do some type of split to have the lower 64 notes assigned to 1st channel, and the upper 64 notes to the 2nd. Then I could assign various notes within those ranges, and somehow filter those notes to go to separate channels to get to the SY-1.

Is this possible with what I have?

I also have an Arturia Beatstep Pro, though I'm not sure this would work with my idea or not.

Last mention is I wish I could use an Alternate Mode trapkat for something like this. Or a malletkat. But kind of pricey.

I appreciate any and all input in advance, thanks!