MIDI Forum

Thanks Bavi. Pure magic. It took me some time to get my head around your answer but by studying a bit the midi implementation manual from the bc man...

After studying a bit the logic behind your workaround Bavi, i realize that it is very hard to program about 20 such values on the bcr. Because of the...

Thanks Bavi for your interest on my subject, your research and the super detailed reply. Marion systems prosynth is very difgicult on data transmissi...

[quotePost id=20691]Correct. If each letter in "LRcccddd" represents one bit, then the data bytes in the SysEx message would be "0000cddd 0000LRcc"...

[quotePost id=20684]If you send zero bits, then those values will be set to zero. If you do not want to change tha values, you have to send the old...

[quotePost id=20658]You can change the parameters and then send the entire memory dump. Doing this when you want to change only a single parameter is ...

[quotePost id=20654]As far as I can see, there is no memory address in the message, so I guess it expects you to transmit the entire memory contents. ...

[quotePost id=20649]The 7th byte consists of two fields, 7 bits for the cutoff, and 1 bit for the trigger mode. If the cutoff is 21 (0010101), and the...

[quotePost id=20472] More information about converting binary to hex: I looked for a document that explains how to convert a binary number to a hex...

[quotePost id=20468] zz: instrument number + hex 18 (instrument number + decimal 24) [/quotePost] I ‘m nearly there Bavi, on most of the backgr...

Thanks a million Bavi and Clemens. It seems like it was much more complicated than the initial simple messages so I have to study it a bit better to b...