MIDI Forum

I am pretty happy with my solution, i think it is pretty accurate.

Eddie says it is easy to calculate the byte/bytes from adress and message, i need a script for that kind of arithmetic.... What does worry me is th...

Thanks, Eddie now i just got to figure out what hex to change for the parts, "and hope i can get it on again LoL"

If you want i could make a small side script to sequenser where our can handwrite midimessages as a hex stream and send by button push, Don't know ho...

Will try that Eddie but i have a feeling that the Roland messages are not generic, because i found this howto turn of parts on SC-55 and others. Did ...

Hello Clemens this morning i tried to decipher what message for channel/part on and off. I must say when the example messages is not stated in clearte...

Well it seem to me one would have to send a program change with each note on midichannel 10 to use two kits. My script do not but i noticed i could r...

From what i get about the kit changing what is really needed is an ins file "instrument description" that also hold the kit programs and bank. I gues...

The errors of setTimeout is gone and so is gone and so is setTimeout replaced with setInterval. setTimeout had been much nicer on the processor thoug...

Or have i got it all wrong and clock signal never sent with the actual midiplayup? It is just a separate synch thing sent over a separate cable? I th...

Maybe my polling of clock "5 ms" not tight enough to give a correct clock timing sent sent over port?

I tried to infuse just a start and clock signal into my sequenser, but my Roland SC-7 behaves strangely like it try to trigger notes on the clock? Do...

I think you mean 480 clicks Mike 480=1920/4 (parts of full note) ?