I program my songs using a roland mc-50 into a roland sc8850. I would like to incease only the snare drum volume (note 38 and 40) by sysex. in certain files. I select either Standard 1 or Standard 2 drum kits. I have used the NRPN 99/98 (26) cc6 - 127 but I'd like the snare to be louder without dropping the overall volume of the file.. Any help would be well appreciated. Joe
Accepted Answer
0
Undo
Votes
Have a look at the section "Drum setup parameters" on page 240 of your manual.
The address you want to write to is "41 m2 rr" where m is the drum map and rr is the note number.
The address you want to write to is "41 m2 rr" where m is the drum map and rr is the note number.
Accepted Answer
0
Undo
Votes
Have a look at the section "Drum setup parameters" on page 240 of your manual.
The address you want to write to is "41 m2 rr" where m is the drum map and rr is the note number.
The address you want to write to is "41 m2 rr" where m is the drum map and rr is the note number.
0
Undo
Votes
Sure. The attached MIDI file will play the same note at the same velocity, but altering its volume with SysEx messages.
(I had to zip the MIDI file to get the forum software to accept it.)
(I had to zip the MIDI file to get the forum software to accept it.)
- Page :
- 1
There are no replies made for this post yet.
